What is the detailed construction method of nano anti-corrosion heat insulation boards

Many customers have misunderstandings about nano anti-corrosion heat insulation board, do not understand the heat insulation board in the construction of some of the basic conditions and knowledge, so that we have a deep understanding of the heat insulation board.

1, positioning: according to the shape of the nano anti-corrosion heat insulation board, select the paste location, try not to cut the anti-corrosion heat insulation board, do not penetrate the anti-corrosion heat insulation board, to maintain the integrity of the anti-corrosion heat insulation board, in order to save materials;.

2, alignment: in order to maintain the upper part of the opening of the furnace lining anti-corrosion insulation board neat, using the construction from the top down, anti-corrosion insulation board construction line requires alignment; anti-corrosion insulation board up and down the left and right should be tight, in principle, the smaller the gap the better.

3, cutting: for shaped parts, need to cut, required to use a steel tape measure to accurately measure the size, and then the anti-corrosion insulation board flat on the ground, with a steel plate ruler in the anti-corrosion insulation board measure the size of the requirements of the accurate to the millimeter, do not allow roughly the difference between the casual comparison; cut anti-corrosion insulation board, with a steel plate ruler pressed to the cut line, the first cutter against the steel plate ruler, and then gently anti-corrosion insulation board surface of the aluminum foil packaging scratch, and then force along the cut line to cut the anti-corrosion insulation board, and then cut the anti-corrosion insulation board surface of the aluminum foil package. Then cut the powder of anti-corrosion heat insulation board along the cutting line with force, and then cut the aluminum foil package of the lower part of the heat insulation felt.

4, sealing: cut the anti-corrosion heat insulation board, to immediately use aluminum foil tape to seal the incision, to prevent the powder from leaking out, do not use the part of the anti-corrosion heat insulation board gently placed on the standby; Note: two cuts should be immediately sealed with aluminum foil tape, to prevent the powder from leaking out and damage.

5, opening: the need to pass through the anchors of the anti-corrosion insulation board, with a special paper cutter in the center of the anchors aligned position, careful not to be too large, do not deviate from the anchors of the center of the position, careful to cut the incision, the incision should not be too large, and do not deviate from the anchors of the center of the position;

6, drilling: if you need to drill holes in the field, you need to use the top and bottom of two plastic plates, the plate open a good hole, the plastic plate to the anti-corrosion insulation board clamped, and then accurately drill holes with an electric drill.

7, seams: for large gaps, you can use the edges of the cut-off material to fill in, outside with aluminum foil tape.